Base mounted nominal 150 gallon capacity reservoir complete with a full containment drip tray.
- Electric immersion type oil heater c/w integral thermostat.
- Shell & tube type heat exchanger water: oil complete with water modulation valve
- Suction strainers for each lube and lift pump
- Oil level sight gauge
- Low oil level float switch
- Mechanical local oil temperature gauge
- Sealed filler neck (recommend force fill through included filter port)
- Filtered breather assembly
- Return oil filter assembly c/w element condition "clogging" monitor with indicator switch
- Drain ports for reservoir and drip tray
Low pressure lubrication circuit components:
- Nominal 8 GPM low pressure lube pump, Max pressure 300PSI - 2 HP, 1200 RPM, TEFC-C faced electric motor
- Shaft coupling
- Pump to motor bell housing
- Relief valve
- Discharge check valve
- Pressure gauge
- 50:50 flow divider valve
- Flow switch and indicator for each branch
- Discharge check valves for each branch
High pressure, lift circuit components:
- Nominal 3 GPM split flow pressure lift pump
- 5 HP, 1200 RPM, TEFC-C faced electric motor
- Shaft coupling
- Pump to motor bell housing
- Relief valve for each branch
- Pressure switch for each branch
- Pressure gauge for each branch
- Discharge check valves for each branch Mounted, piped and plumbed in a single unit. The unit has 2 X termination for lube supply to mill, 2 X termination for lift supply to mill, 2 X termination for sump returns from mill, 2 X termination for cooling water supply and drain and 1 termination for oil top-up/filling through the filter. Complete with legs, lifting lugs and painted standard blue. Field piping, bearing terminations, electrical device wiring, and lube oil are not included.
